Do you know about the hydraulic transmission system of the automatic CNC lathe machining center?

Auxiliary equipment of automatic CNC lathe machining center From the surface, the rotary table is similar to the indexing table of the general machine tool, but its structure type also has its own characteristics. It is mainly composed of a transmission device, a gap removal device and a worm gear and worm clamping device. Mainly to carry out the round-up knife fitness exercise; to carry out the indexed fitness exercise. The indexing operation table is different from the rotary table of the CNC machine tool. Its effect is to complete the indexing fitness exercise. The difference from the rotating table depends on the indexing operation table. The knife cannot be moved on a circle. The fitness movement of the indexing console is limited to the required viewing angle, such as: ninety degrees, sixty degrees, and forty-five degrees. The indexing table has very clear regulations for its own high precision, so it must be used in conjunction with the precise positioning mechanical equipment, so as to ensure the safety factor in the work of the machine tool.

Fully automatic CNC lathe tool changer: The fully automatic tool changer is the characteristic structure of the processing core that is different from other CNC machine tools. It has the function of automatically replacing the required tools according to the requirements of the processing technology, so as to help the CNC machine tool to save auxiliary time, and to achieve the requirements of multi-process and process processing in one installation. Therefore, in the application, special attention should be paid to always check whether the operation of the mechanical system of each component of the automatic tool changing equipment is in normal operation, whether there is any abnormal situation; check whether the lubricating oil is good, etc., and pay attention to changing the tool. Stability and security checks. (1) Check, filter, and replace the oil in the oil tank on time; (2) Check the operating characteristics and operating temperature of the cooling tower and electric heater; (3) Regular maintenance Remove and replace hydraulic seals to avoid leakage of hydraulic transmission system;

The three-jaw chuck is the main accessory for clamping the workpiece during milling of CNC machine tools. For general rotating parts, a general three-jaw chuck can be used; for parts whose clamping position is not cylindrical, a special hydraulic chuck must be used. A torsion spring hydraulic chuck must be used when machining parts with a round bar immediately. For parts with a large ratio of radial size to axial size, it is necessary to select a support point at the tail of the part installed on the tail frame of the hydraulic press to ensure proper machining of the part. The tailstock includes ordinary hydraulic machine tailstock and programmable controller hydraulic machine tailstock.